EcoSmart ECO-6 Bedienerhandbuch PDF herunterladen (Seite 18)

10. Service on Your

Machine

Your disc repair machine

deals with a significant

number of variable

factors. The friction

between the disc and

the sanding pads

changes constantly as

the pads are gradually

worn down. The water supply can vary a little due to small air bubbles in the line. The

amount of Solution “D” can vary if the water is not mixed properly or the bottle of supply

water is not shaken or stirred occasionally. The pads may not be centered on the pad

holders. All of these factors determine the friction during the repair process and the

operation of the machine. The machine is under software control and if the electrical

sensors in the machine detect changes in these frictions, it is possible that error

messages may occur from time to time that are temporary in nature. These temporary

errors can usually be addressed by changing the pads or just turning the machine OFF

and then ON again to reset the electronics.

In the unlikely event that a persistent problem occurs, note the error code (if any) and the

nature of the problem, turn off the power switch, and unplug the machine. Please contact

the RTI Service Department.

Please have the following information available:

• Approximate date you received the machine

• Model Name of the product

• Serial Number (Located on the rear Identification label)

• Problem description (please provide as much detail as possible).

If the machine needs factory service, make sure to include your name and address, phone

number, and a description of the problem with the machine. Repairs can cost more and take

longer without this information.

RTI Group

4700 Chase Ave. - Lincolnwood - IL -

USA - 60712

Phone: 1-800-323-7520

Fax: 1-847-677-1311

E-mail: service@rtico.com

1 2 ... 13 14 15 16 17 18 19

Keine Kommentare

EcoSmart ECO-6 Bedienerhandbuch Seite 18